HPE6-A80 Dumps - Grab Out For [NEW-2022] HP Exam
HPE6-A80 Exam Dumps PDF Guaranteed Success with Accurate & Updated Questions
NEW QUESTION 20
An archinect needs lo plan a Mobility Master (MM) solution for a customer Requirements include:
* redundancy for the MM
* redundancy for the MCS (seamless failover if up to one fails)
The wireless network consists of
* total APs - 300
* total wireless devices = 20,000
* total MCs = 10
The customer wants the most cost-effective plan that meets me requirements.
Which plan for MMs should the architect select?
- A. 1 MM-HW-5K and 1 MM-VA-1K
- B. 2 MM-HW-5K
- C. 2 MM-HW-1QK
- D. 1 MM-HW-5K and 1 MM-HW-1K
Answer: C
NEW QUESTION 21
For which scenario do Aruba CX 6300M Series switches meet the needs for an upgrade of the wired access layer while the Aruba CX 630QF Series switches do not?
- A. The Aruba CX 630DM support up to 75W PoE+ per port
- B. The customer wants to utilize the Aruba AP-515 support for 002 3bz connectivity.
- C. The Aruba CX6300M supports 10GBase-T connectivity with AP-515.
- D. The customer wants to utilize LACP on AP515 in VSF switch configuration.
Answer: A
NEW QUESTION 22
An indoor sports stadium has 5.000 seats in two rings:
* The stadium has a ceiling height of 72 feet (22 m).
* There is a catwalk around the perimeter of me stadium that is 54 feet (13 m) from me floor.
* There are two scoreboards at either end of the stadium
* The construction of the stadium is concrete and steel.
The customer has indicated a preference for overhead coverage, and the wireless network should support 3500 concurrent clients. The architect plans to install the APs on the catwalk to service sections of the floor below Which type or antennas are recommended for the APS that provide the overhead coverage?
- A. high gain omnidirectional
- B. downtilt
- C. vagi
- D. high gain directional
Answer: D
NEW QUESTION 23
Refer to the exhibit.
A customer needs to support resilient wireless services
What is one way that this design helps to minimize me impact of a railed access layer switch on these services?
- A. Each access layer switch has two redundant links to the core.
- B. The switches support Smart Rate and dual home AP connections.
- C. APS in the same area connect to different switches.
- D. The 8400s and G405s use Virtual Switching Extension (VSX) in cone and access.
Answer: B
NEW QUESTION 24
in which scenario do Aruba CX 6400 Series switches, but not Aruba 6300M Series switches, meet the needs Tor a wired upgrade?
- A. The customer requires each access layer switch to support at least 25Gbps on its fiber uplinks at all times; including if up to one uplink tails.
- B. The customer requires enhanced redundancy at the access layer and wants to ensure that each switch can continue to operate even if a power supply fails
- C. The customer has recently deployed Aruba AP-535 APs and is concerned about a future-proof wired edge that will continue to support expanding bandwidth requirements.
- D. The customer requires switches in the same closet to operate together as a single switch for Link Aggregation but to be managed as separate devices.
Answer: D
NEW QUESTION 25
What is one benefit that Airwave provides to customers in the 8.x OS network?
- A. ability to monitor the status and operation of the complete network over time
- B. a central UI from which to manage all of the Mobility Controllers (MCs)
- C. in-depth analytics oT mobile device presence and APIs to make this data available to other applications
- D. profiling of wired and wireless client behavior and detection when the behavior varies from the baseline
Answer: D
NEW QUESTION 26
A customer has a large network, which includes a main site and many branch sites. The network has a total of about 10.000 wireless devices at the main site and 15,000 wireless devices total at branches.
To fulfill the requirements for a wireless network upgrade, the architect plans to propose;
* 2 7205 MCs at the main site
* 2 7210 MCs at the main site
* 10 7030 MCs at branch sites
* 200 RAPs at branch sites
* 500 CAPS at the main site
* 300 CAPS at branch sites
What is the most cost-effective Mobility Master solution that meets the requirements'?
- A. MM-HW-1OK appliance
- B. MM-HW-1K appliance
- C. MM-HW-5K appliance + MM-HW-5k appliance
- D. MM-HW-5K appliance
Answer: C
NEW QUESTION 27
Refer to the exhibit.
A customer needs a wired network upgrade and has complained about performance issues. The architect collected information about traffic now on several switch ports in different locations across the network, and the results are shown in the exhibit. Each of these ports is a 1Gbps port.
What can the architect conclude?
- A. None of these ports show any periods of congestion
- B. Port 3 snows periods of congestion; other ports are not congested.
- C. All of the ports show serious congestion
- D. Port 1 shows periods of congestion; other ports are not congested.
Answer: A
NEW QUESTION 28
A customer has an existing Aruba wireless solution at their campus. This solution is shown in the exhibit.
The customer now wants to enhance seamless roaming and failover across the solution. The customer wants the least expensive solution that still meets the needs.
Which figure shows the correct changes to the solution to meet the new needs?
A)
B)
C)
D)
- A. Option A
- B. Option C
- C. Option D
- D. Option B
Answer: A
NEW QUESTION 29
Refer to the exhibit.
A hospital needs an upgrade to 802.1tax for its wireless network. The wireless network supports:
* wireless medical devices
* medical staff voice communicators
* laptops in nurse stations
* medical staff tablets
* visitor and patient personal devices.
All of these devices support both the 2 4GHz and 5GH2 band. Assuming about a max throughput on50 Mbps per AP; the hospital would like. The architect has used VisualRF to plan the AP placement on one of the floors, which the hospital expects will need to suppod about 800 win to deploy APS in stairwells between floors.
How well does the plan meet the requirements?
- A. The current AP placement meets coverage requirements, but does not meet capacity requirements.
- B. The current AP placement meets the customer requirements in terms of coverage and capacity.
- C. The current AP placement fails to account for the lead-lined wails that are common in patient and exam rooms.
- D. The current AP placement fails to provide adequate signal for the voice communicators in several areas
Answer: C
NEW QUESTION 30
Compare the scenarios below. For which scenario do AP-575S meet the needs?
- A. The customer needs APs for an Indoor nigh density environment In which tne customer prefers dual 5GHz operation.
- B. The customer needs APS mounted to a concrete building exterior to provide coverage in a 90 foot (27m) radius from the building.
- C. The customer needs APs for an indoor stadium that requires overhead coverage and directional antennas.
- D. The customer needs to mount APs in an outdoor area, but that area only has fiber cable available,
Answer: D
NEW QUESTION 31
Refer to the exhibit.
The exhibit shows the current AP deployment In a warehouse that stores frozen food goods:
* APs are mounted on the ceiling, which is 15 feet (4.6 m) high.
* Shelves are 12 feet (3.7 m) high and are typically fully stocked.
This customer indicates that their current wireless performance is inadequate.
What should the network architect include in the new solution to resolve this issue?
- A. APs deployed with directional antennas on the ceiling, due to the high 15-foot callings
- B. APs deployed with directional antennas and a hybrid wall-mount, ceiling-mount design
- C. APs deployed on the ceiling in each aisle, due to the high absorption between aisles
- D. APS deployed on the ceiling in the same current locations, out with dual 5GHz radios
Answer: C
NEW QUESTION 32
What is one reason to deploy an Aruba CX switch when compared to an ArubaOS switch?
- A. to obtain higher wattage power modules for enhanced PoE+ support
- B. to support Aruba Dynamic Segmentation
- C. to obtain API-enabled programmability for greater automation
- D. to support Zero Touch provisioning (ZTP)
Answer: A
NEW QUESTION 33
Refer to the exhibit.
A customer has these availability requirements;
* loss of one controller with stateful failover and without impact on wireless client connectivity
* loss of one core switch without loss of connectivity for any endpoints or APs in the building
* loss of any one switch-lo-switch or MC-to-switch link without loss of connectivity for any endpoints or APS in the building and with minimal impact on infrastructure functionality
* loss of any one access switch with minimal impact to wireless client connectivity The exhibit shows the current plan for the topology.
Which change should the architect make to the plan to provide better support for the customers availability requirements?
- A. Add 120 additional AP licenses, so that each MC can support ail the APs, even if the other MC fails.
- B. Use two 40GBE DACs between the core V3X switches for their switch links.
- C. Change the 40GbE DAC on the 8400 switch to a stacking cable with stacking module.
- D. Add VLANs 11 and 15 to the MC connections to ensure both MCS can manage any of the APS.
Answer: A
NEW QUESTION 34
Refer to the exhibit.
The exhibit shows the design for an existing network. The customer intends to replace the current Core switches with two Aruba 8400 switches.
What are two points that the architect should ensure that the customer understands? (Select two.)
- A. The 8400 switches run different software than the 5400R switches.
- B. The 8400 switches do not support VSF.
- C. The 8400 switches cannot be monitored by AirWave.
- D. The 8400 switches are fixed port switches.
- E. The 8400 switches have a smaller ARP table than the 540OR switches.
Answer: A,E
NEW QUESTION 35
A retail customer is doing a wired and a wireless refresh with Arut>a CX switches and S02.11ax APs. Currently, trey nave wireless Point of Sales (PoS) systems and would like to assure that the proposed deployment solution will comply with the Payment Card Industry (PCI) Data Security Standard (DSS) requirements.
The architect have proposed the following deployment solutions regarding PCI DSS requirements'
-IDS/IPS
-Aruba APs in hybrid mode as well as in dedicated AMs mode
-Strong authentication and encryption for wireless
-Built-in firewall and role-based access controls to segment WLAN
Which other requirements must you include in the existing deployment solution? (Select two.)
- A. Aruba Central or Aruba AirWave to generate a scheduled compliance reporting.
- B. Select the FIPS/TAA-compliant version for the Access Points.
- C. Switch high-availability solution VSF and VSX also can encrypt all traffic on their switch links.
- D. Role-based access controls for wired users using ClearPass. Optionally ; tunneled-node to MCs.
- E. Suggest MACSet between the Aruba CX switches that encrypt all traffic over the link.
Answer: A,D
NEW QUESTION 36
Refer to the exhibit.
A company needs a new wireless solution for its multi-site network. All branch sites must connect to the main site through secure tunnels over the Internet. The customer requires full redundancy for the Mobility Controllers (MC). Including stateful faiEoverand seamless roaming for the main site.
The architect plans to propose:
- 500 RAPS
- 100 APs at the main campus
- two 7205 MCs
- two 7210 MCS
- one MM appliance
The exhibit snows the existing wired network at the main site, which has a single building with two large floors.
Following the best-practices on design, performance and security, where should the architect plan to connect the MCs?
{Potential locations are numbered in the exhibit.)
- A. all of the MCs at 2
- B. two 7205 MCS at 1; two 7210 MCS at 2
- C. one 7205 MC at 3 and one at 4; two 7210 MCs at 1
- D. two 7205 MCs at 2; two 7210 MCs at 1
Answer: A
NEW QUESTION 37
A nospltai needs an upgrade to 802.11ax for its wireless network, which needs to provide complete coverage The hospital has a concrete exterior and uses drywalls lor all of the interior walls with a few exceptions as mandated for safety The building has 10fool (3 m) ceilings.
The hospital prefers to avoid the deployment of APs in rooms if possible. Exceptions include reception areas and lounges.
The wireless network must support wireless medical devices, voice communicators for medical star, laptops in nurse stations, medical staff tablets, and visitor and patient personal devices. All of these devices support both the 2.4GHz and 5GHz band.
The exhibits below show one wing of one floor of the hospital. This wing is about 2S.Q0D square feet {2GQQ sq, m). The unlabeled rooms along the bottom of the wing are patient rooms' other rooms such as lounges and the MR] room are labeled. This area has:
* up to SO concurrent patients and visitors, who might have up to two devices
* 40 concurrent staff members, who might have up to three devices
* about 200 medical and other types of wireless devices
The architect has already planned to place APs in stairwells on another floor.
Which AP plan for this wing of this floor meets the customer needs?
A)
B)
C)
D)
- A. Option A
- B. Option C
- C. Option D
- D. Option B
Answer: A
NEW QUESTION 38
An indoor basKetbaiI stadium has 5.000 seats in two rings:
* The stadium has a ceiling height of GO feet (18 m).
* There is a catwalk around the perimeter of the basketball court, between the court and the seating areas.
* This catwalk is 40 feet (12 m) from the floor.
* There are two scoreboards at either end of the stadium.
* The construction of the stadium is concrete and sleet.
The customer does not want an under-seat, picoceli deployment.
Which AP model is appropriate to provide coverage in the main stadium bawl?
- A. AP-555
- B. AP-505
- C. AP-577
- D. AP-575
Answer: C
NEW QUESTION 39
......
Get New HPE6-A80 Certification Practice Test Questions Exam Dumps: https://actualtests.torrentexam.com/HPE6-A80-exam-latest-torrent.html
